Carpets & Flooring · 6 min read · 11 July 2026
Why Is My Floor Squeaking? Diagnose It in 10 Minutes (and Fix It Properly)
A squeak is never the timber complaining — it is two surfaces rubbing. Work out which two, and most repairs take twenty minutes and cost under a fiver.
By the Nims Casa editorial team — written from professional cleaning experience and checked against our editorial standards.

Almost every squeak is one of three things: a nail shank moving in a hole worn oversized, one board edge rubbing its neighbour, or a board lifting off a joist it no longer sits tight on. Identify which and the repair is usually twenty minutes and under a fiver. Guess, and you lose a Saturday lifting boards in the wrong room.
Age matters here. A 1990s house has 22mm chipboard glued and screwed to joists at 400mm centres, so squeaks are rare and mean a failed glue line. A Victorian house has square-edge softwood nailed onto sawn joists with cut nails: no deck, no glue, 130 years of shrinkage, and gas pipes and old cable hidden in notches. The diagnosis is the same in both. The fix is not.
The 10-minute diagnosis
- •Work in socks, first thing, heating off. Timber at 15C squeaks noticeably more than the same timber at 21C.
- •Cross the room in a grid, 300mm at a time, rolling your weight rather than stepping. Tape every noisy spot — the pattern is usually a line, not a scatter.
- •Press with one foot either side of the mark. Quiet when you load the neighbouring board means the joint is moving; quiet only when you stand over the nail heads means the fixing has failed.
- •With a cellar or accessible void, watch the joist from below while someone walks above. A board lifting off the joist is a fixing fault; movement in the joist is more serious.
- •On laminate, LVT or engineered board, press with your palm. A hollow tick that travels with you is underlay, screed or expansion gap — rarely the plank.
Symptom to cause: what each noise means
- •Short dry chirp in the same spot every time — a nail shank sliding in a worn hole. The commonest fault in any pre-1940s floor.
- •Deeper groan across 400-600mm, several boards together — the joist is deflecting, often because it was notched too deep for a waste pipe.
- •Rhythmic creak along the room — board edges rubbing after shrinkage. Common in the first two winters after a boiler upgrade or a wood burner.
- •Sharp tick under laminate or LVT — no expansion gap at the perimeter, a proud screw head below, or grit under the underlay.
- •Squeak with bounce underfoot — stop testing and start investigating; the signs of subfloor damage matter before you put a screw near it.
- •Squeak that appeared weeks after bathroom or rewiring work — somebody lifted boards for access and refixed them badly.
The likely causes, commonest first
Ordered by how often they turn out to be the answer on a UK callout.
- •Worn nail fixings. Cut floor brads grip well until the hole wears; after that they never re-grip, and tapping them down buys a fortnight.
- •Shrinkage. Victorian boards were laid at 14-16% moisture content; central heating has taken them to 8-10%, opening 2-4mm gaps that let edges rub.
- •Boards refixed after services work — cut short of the joist centre, then nailed into the old holes.
- •Missing strutting or over-notched joists. Herringbone struts stop joists rolling, and a 40mm notch in a 175mm joist halves its stiffness at that point.
- •Floating floors with no expansion gap, or over a screed out by more than 3mm in 2m — why flooring installation mistakes show up six months late.
- •Damp or decayed joist ends in a solid wall: least common, most expensive.
Fixes ordered by risk, lowest first
- •Powdered graphite or talc brushed into the board joint. Ten minutes, about £3, silences an edge-rub squeak for six to eighteen months. Useless on a nail squeak.
- •From below: a hardwood shim dipped in PVA, tapped gently into the gap between joist and board, then trimmed. Thirty minutes, £5, permanent, nothing above disturbed.
- •From below: a 75x50mm noggin glued and screwed between joists, tight under the board. Best fix for a deflecting but otherwise sound joist.
- •From above: countersink 4.0 x 45mm woodscrews through the board into the joist centre, two per board, replacing the failed nails rather than sitting beside them. Pellet or fill if the floor is on show; about £8 a room.
- •Floating floors: lift the skirting and re-cut a full 10-12mm expansion gap on every edge, including doorways and pipe collars.
- •Last resort: bolt a new C24 joist alongside the failing one. £60-120 in timber, but the ceiling below comes down — our guide to fixing squeaky floors covers the sequence.
Why old houses squeak differently
Solid-wall period properties behave nothing like a modern build, and the usual advice to screw down from below can cost you a ceiling.
Never drive a screw blind into a pre-1970s floor. Lead and copper gas runs sit in joist notches, and rubber or VIR-insulated cable is often clipped to joist sides with no capping and no earth. Use a detector, then lift a board at each end of the run and look — and in a house with original circuits, read up on old wiring safety first.
- •Lath and plaster ceilings hate percussion. Screwing up into joists is fine; hammering is not. One session with a mallet drops the ceiling, and repairing old plaster costs far more than the squeak did.
- •Pull cut nails, never punch them, and never glue or secret-fix Victorian boards. That floor is the service duct for the whole storey — screws let you lift it again.
- •Joist ends in a 9-inch solid wall are the weak point. Squeaks clustering near a south-west elevation mean checking the void for driving rain, a blocked airbrick behind new render, or a raised patio killing cross-ventilation — a damp problem, not a joinery one.
- •Seasonal squeaks are normal in a lime-plastered house. Noise arriving in October with the sticking sashes and going in April is humidity moving the building, one of the ordinary problems in 100-year-old houses.
- •A new squeak beside a soil stack under an upstairs bathroom, with staining on the ceiling below, is a leak until proven otherwise.
What it costs, and when to stop
DIY materials run £3 to £25. A joiner charges roughly £150-£220 for a half day outside London, £250-£320 inside the M25, and usually silences a whole floor in that time. Lifting and relaying a 12m2 bedroom of original boards is £450-£900 in labour; sistering joists £400-£800 per room including making good the ceiling. If you are sanding anyway, fix the squeaks first — nearly free at that stage, miserable once the floor has been refinished.
- •Stop if the floor bounces or has dropped more than about 6mm across a doorway. That is not a squeak, and sagging floors need eyes on the joists.
- •Stop if timber near a wall is soft to a screwdriver point, smells musty, or shows fruiting bodies — rot must be identified first.
- •Stop if a detector reads metal or your pilot bit meets resistance. Lift the board and look.
- •Stop if the property is listed and original boards are affected — consent can apply, and matching reclaimed boards are not cheap.
- •Stop if you are in a leasehold flat: the lease often governs the floor build-up on acoustic grounds.
Found this useful?
There's plenty more — hundreds of guides and honestly-tested product reviews for every corner of your home.
Browse All GuidesKeep reading

Carpets & Flooring · 5 min read
Flooring Installation Mistakes to Avoid (And How the Pros Sidestep Every One)
Most floor failures we see aren't product failures — they're fitting failures. Here are the mistakes that lift, gap and creak boards within a year, and exactly how to avoid each one.

Carpets & Flooring · 5 min read
How to Refinish Hardwood Floors: The UK Step-by-Step Guide (Grits, Costs & When to Stop)
Most tired hardwood floors are not worn out, just worn through. Here is the professional sanding sequence, honest UK hire costs, and the five situations where you should put the machine down.

Carpets & Flooring · 7 min read
How Much Does Flooring Installation Cost? UK Prices for 2026
Two fitters can walk the same lounge and quote £900 apart without either of them trying it on. Here is what UK flooring actually costs per square metre in 2026, line by line.
Keep your home in brilliant shape
Hundreds of honest guides and tested product reviews — written from real hands-on experience.